castle/neu rotor stripped
 

today i did some 10 mins driving on my castle/neu motor in my truggy
and came home with this

http://www.mijnalbum.nl/Album=IHFANMJO

is this in warranty ?
i think its caused by a bad bearing there was some play in the bearing

greets nvt

Bad bearing would make sense- the rotor doesn't look damaged really, just taken a little of the epoxy off the kevlar strands ( if it was damaged too much then the magnets would have shattered during use ). If only one bearing is bad, I would just replace it with something a little better- there are top-quality bearings for ~$1 each if you look around ( Boca bearings, or Acer ceramic bearings are great ).

Otherwise, you could pay ~$25? for a new rotor and 2 new bearings ( repair kit ), or send the motor to castle to have it inspected and the bearing/ rotor replaced if required.

How old is the motor?

the motor was 2 runs old
and i don't trust it now its stripped.
It is probably out of balance now and will eat bearing when i'll just run it

greets nvt

some opinion from castle ?

greets nvt

or a coupon code for free shipping ?
+/- 30 dollar shipping is pretty much.

so i could order a motor repair kit ?

greets nvt

lets get this one up again still got this motor laying here want to fix it so i can bash my
full carbon savage again

greets nvt

I'd contact tech support and let them know what happened.

Patrick

http://www.castlecreations.com/support/repairs.html

http://www.castlecreations.com/support/contact.html

Remember that this is just a section on a forum website, it is not an official support forum that is monitored or staffed by castle reps on a permanent basis- if you need specific help or info about repairs, you need to contact castle more directly.