Neu motors
 

I want to start a thread about these motors. I just got one to try in my buggy and truggy, and I will post some results when I get some wheel time.

Mine is a 1512 1.5Y

The initial brief test run showed the motor to run very cool, but we'll see what happens with a full run... bashing and on the track.

One FYI about the motors I picked up from the info that came with it... the smooth non-finned can motors apparently have a non-standard mounting screw spacing.

The finned cans have a standard screw hole spacing, but the smoothies have a smaller spacing... I think it was 25.2mm vs 22mm.

I don't have the sheet with me. I will correct that if it's wrong...

Can you post some pics of the motor? I'd like to see how open the design is on both ends.

Sure... I won't be able to until late tonight/tomorrow morning though.

Is it open on both end or just one?

I got one coming to me as well. I want to test it in a gmaxx.

Will these motors work with a BK warrior 9920 or a shulze 18.97 ?.

open on both ends. I'll go get some pics now......

They won't work on bk but will on the schulze. They are 4 pole motors.

Thank's leroy:027: .

It work with the quark as well. I know you don't have one hippie. You may get one one day. Just covering it just in case others interested. :D

that really sucks for us BK owners.......maybe we should contact BK & ask them if they can do a software update....so they can be run on these motors as well....just a thought

Here are pics of the front and rear. The front has four big holes and the rear has five smaller holes, plus the three wires.

I going to try to make a cover for the holes. I don't like dirt going in my motor. Sounds like trouble. Especially if you get any iron it will go right to the magnet. Sounds kind of diaster in the making.

I just plan to cover them with electrical tape.

Hmmm, I'm not too keen on the holes, although I'm sure they help with cooling. I think I might stick with my original LMT plan...