RRP Slipper
 

hey guys will the Robinson Racing Small Slipper Clutch Plate Traxxas, work on the ofna 51 tooth spure?:013: pic:

Yea, it just requires a few holes to be drilled. It's actually slightly smaller than the spur so be sure to make it lined up.

yes it works. i just pressed the cluch plate in the spur with the vice and drilled new holes. one thing you will have to do is grind down the original holes to fit the slipper plate on.

Cemetery, I think you have the large one and not the small one.

any of you have a picture of it onn?

i have the small clutch plate, the ones that comes with the 66 spur.

mike, you can see a pic in this thread

http://www.rc-monster.com/forum/showthread.php?t=3923

Thats odd...I coulda swore mine dropped in the 51T spur witha few mm on each side. I could be mistaken though...

mine was just like .25mm short of just dropping into place so i pressed it in and it was perfectly round too...

do you still need the strobe pads or from there you can use the rrp slipper clutch ect... pics anyone???

I don't have pics, but i run the rrp on my girls mostly stock set up and the pads are fine...the reason most people go with the strobe is because the mod 1, the pads, and durability. But the rrp is fine.

You just can't allow any slip...

Make sure it's tight!!!! I;m taking hers off to put the strobe on it, i don't have any pinions that are 32 pitch besides a 16, and it's way tooo much torque! But i have like 4 5mm pinions for her if i use mod 1 with the strobe....so my gearing options are better, especially cuz she's running only 14 cells!