LIPO's
 

Eventually I will be upgrading to LIPOS and I think I want 2 batterys 3s each.

I have a 1950/6 hi amp and a bk 20150 controller. What does everyone think?

i think that you should run 4s or 5s at the max with that motor, not 6s. i could be wrong though.

btw which lipos?:032:

6s on that motor should scream. It may push it a little. You going to need some good amp ratings.

Thread moved to General Electric.

These are the batteries I was thinking about getting.

2 of them.

MaxAmps Lipoly 8000mah 3S2P 11.1V Pack.

Then put them in series and run 22.2 Volts.

By the way, trying to hit the 50's or 060's mph.

I would run 5S. 6S will be pushing it...

6S is too hot on this motor.
What lipo's are you going to use? there are many different lipo's available.

My opinion. The lehner is better built and the 1950 6t is close to the 7xl.
6s May push the motor a little. With a good heat sink I think it will take it. I
I would not try it with 7xl though.

it's KV rating is 2090... with the amp drop and everything the motor will run at around 45000 rpm with 6s? it should be fine, IMO..

No, it's rather hot.

that 45000 is at load.

I came up with over 50K rpm's with no drop in voltage. Thats given MAX voltage possible...

Too hot.. :p

Exactly...