FLM emaxx tranny half case ?.
 

I need to buy a new emaxx tranny case for my EVO . I was thinking about the FLM half case for the emaxx tranny, i already have the Gmaxx single speed conversion. I think i remember reading about the two items not fitting together properly. If this is true has this situation been fixed ?.

Yes, they should fit together just fine. If not, Mike will take care of ya.

I had issues with the idler. The two supports are too close to eachother. The input gear (not shaft, gear) needed to be made smaller too.. (only a little though)

I thought these problems are gone now.

I had the same problem with mine and finally figured out that it was made only for the single speed conversion. I was trying to fit the whole tranny in it and it wouldn't work.