My project Black Fury finished!
 

Hi!

I have just tested for the first time my Savage brushless (Shultze/Hacker C50).



Vidéo :
http://www.dailymotion.com/manulesur...shless-1-essai

(google : http://video.google.fr/videoplay?doc...95289618471716)

Complete presentation with a lot of photos :
http://www.maximummt.com/phpbb/viewtopic.php?t=34593

I will try to present to you this project with more details in next days.

Nice! remember to get me some pics once you smoked the schulze!!

What diffs did you use?

I'm using diffs of CEN Genesis (last generation) with adaptation of the heavy duty diff shafts of hpi.

You think I will smoked the Shultze???

Yeah, i saw these large teeth. was it a 1:1 fit with te diffs?

i hope your schulze stays in one piece! lets hope you don't burn it, since their service is hilarious.

Sorry, I don't understand your question.
It is not the same rapport :
Genesis : 26/9
Savage : 43/13

It's a little more long.
Is your question?

Oui! Merci beaucoup..

The 3mm thick shaft is nice!

You drilled the savage drivecup from 2.5 to 3mm?

It looks great,nice job.Those are some meaty diffs.Motor position is nice.I like the plate for the rear tie rods,that makes room for the shocks i assume?

One little thing,i'd double up on the g-maxx battery straps,use 2 on each side,they tend to snap unless you do.A lot of people have found that out the hard way.

Serum :005: , my English is so bad!!!!

Yes I drilled th diffs shaft from 2.5mm to 3mm.
Filled the diffs of 50 000 silicon oil.
Diffs of Genesis are hards. Very good configuration for trial.


Yes Gustav, the brace is for deporting rear tie rods. It's a 5mm kit from Innovative RC for mounting LST Shocks on a Savage.

The innovative RC shocks ROCK!!! they are CNC machined.