charger/balancer question
 

so im using the hyperion 1210i and the lba10 balancer. when i plug up everything it all seems fine but when i go to charge it it sais "output battery connect error"

what can cause this? im charging a 2s 8ah pack and using a custom PC PS.

thanks!


o and WAHOO!! old rcm is back!

You gotta press the mode button on the LBA10 so the LED is flashing...

You only need to update the avatar t-maxx.

hmm i will try that. but the 2s light is flashing

when you first plug in the balance harness press the modr button once and the led that says lipo 3.7v should begin to flash intemittently--then proceed with your charge.

I just got one of these balancers and the only "Mode" led I can get to come on is the A123 led. The LiPo led will not come on. Any ideas?

probably you pressed the "mode" button during your trials and switched the lba10 to a123 mode. I got the same issue and, by re doing carefully the steps and pressing (one or twice) the mode button when connecting the pack to the LBA10, I came back to lipos.

And then you may charge with the 1210 without problems.