Help. Cant program 9918
 

my red jumper broke again. So i resolderd it on and now im trying to program it. Well i follow the instructions and after i plug my batts in it beeps. Ok next step. I go to full throttle and then it doesnt beep. i held it for 30 seconds and it still doesnt beep. so then i went to full reverse, and it still didnt beep. Whats wrong?:P:

How did you break the jumper? I would first check the obvious things, like the radio(tx and rx on same channel, etc.) . Also make sure the throttle channel isn't reversed, as this can sometime create a headache when trying to program the controller.

The jumper broke off some how, i have no clue, must of been when i was bashing and fell on my rear body post(where the controller is) Ive checked the obvisious, i have 2 different rx, 2 different reciever packs, and 3 different channels. Ill test the reverse on the transmitter. Could i send this in to you for repair?

If you don't get it figured out, you can send it back to me. I can likely find a spare programming jumper to solder on for you.

Ok, ill keep that in mind for future reference. I got it to work finally. I used my brand new gp3700 and that seemed to do it.

If you loose or break the jumper itself not the pegs. Go to a computer store. The jumper on back of a hard drive or cd player will work the same trick.

I broke the pegs and lost the jumper.

I had to reprogram my ESC Again and now im having a problem with making the program stay. I use to solder a wire for a permenant jumper but its not working anymore. I program it, and then when i go to solder the wire on. I solder it turn everything off. Plug the batteries back in and it wants to program again. Any ideas?

Also if i send it in to you Mike, how long will it take for you to fix?

Can anyone help? And have you gotten my email yet MIKE that i sent a week ago?

If you got the board too hot while soldering your permanant jumper on and off, you may have damaged the board. If you sent an email a week a go, I have no doubt replied by now(almost never more than a day goes by for replies). Check your junk email folders.
If the board is damaged, I can't fix it. I would need to send it to BK.

Ok. I'm going to purchase a new 9920. Could i send you a moneyorder for the price and send you my 9918. And if you could fix it can you, or could you send it to BK.:032:

Yep. :)

Thank you. Expect a money order and a 9918 this week.:028:

I just went through the same problem your having, you have to have your remote set up right, before you program,what remote are you running?

The stock HPI Savage one. But i dont see where your going with this. My 9918 wont keep its program. Thats my problem.