RC-Monster Forums  

Go Back   RC-Monster Forums > Search Forums
Reload this Page Search Results

Showing results 1 to 11 of 11
Search took 0.02 seconds. Search: Posts Made By: wevie
Forum: Revo 08.06.2008, 11:11 AM
Replies: 13
Views: 3,742
Posted By wevie
What did you use for tire size? Won't the Slayer...

What did you use for tire size? Won't the Slayer have the same size tire as the Slash? Slash is 4.37" diameter for a 13.7287 circ.

Also, refresh my memory, what are the stock Revo tooth count on...
Forum: Revo 08.06.2008, 04:16 AM
Replies: 7
Views: 1,906
Posted By wevie
Bent hinge pin or stuck pivot ball both sound...

Bent hinge pin or stuck pivot ball both sound like good advice. I've had pivot balls too tight cause the same effect.
Forum: Revo 08.06.2008, 04:13 AM
Replies: 13
Views: 3,742
Posted By wevie
What do you all think of the gearing change in...

What do you all think of the gearing change in doing a Revo 2.5 -> Slayer conversion? To do it right would require new tranny case and gears as Traxxas changed the gear ratio to accomodate the...
Forum: Castle Creations 08.06.2008, 04:10 AM
Replies: 6
Views: 2,598
Posted By wevie
Ok, next question. . . gearing. Would I be...

Ok, next question. . . gearing.

Would I be able to, or even required to change the gearing when I go from a 5700 on 2s to a 5700 on 3s? (T4)
Forum: Brushless 08.06.2008, 04:04 AM
Replies: 14
Views: 2,611
Posted By wevie
I am aware of the crap battery packs that are run...

I am aware of the crap battery packs that are run in the truck. But, as stated, I buy them six or more at a time, hand them to the kids, and let them beat the snot out of them. If they burn them...
Forum: Revo 08.05.2008, 09:37 AM
Replies: 13
Views: 3,742
Posted By wevie
Sounds like the 70 might be just the ticket. ...

Sounds like the 70 might be just the ticket. Guess I'll wait around a bit and maybe buy a quart of nitro. . . ewwwww. :(
Forum: Castle Creations 08.05.2008, 01:44 AM
Replies: 6
Views: 2,598
Posted By wevie
CMS36-5700 vs 6900

I have a T4 running a MM5700 combo. Normally I run the truck on 2s. Just for kicks today I wired two 2s packs in series and added a receiver pack. Since the 5700 is not rated for 4s I only ran a...
Forum: Brushless 08.05.2008, 01:20 AM
Replies: 14
Views: 2,611
Posted By wevie
After checking things out thoroughly today: ...

After checking things out thoroughly today:

1.) He is due for new wheel bearings. They are not smooth, but they are not shot, either.

2.) Unable to locate any physical drags, I plugged the...
Forum: Brushless 08.04.2008, 08:26 AM
Replies: 14
Views: 2,611
Posted By wevie
I know better batteries make a difference. I let...

I know better batteries make a difference. I let him run my LiPo's when I'm bashing with him, but for an inexpensive battery, I can buy him a box full of the Tenergy packs, let him run them and...
Forum: Brushless 08.04.2008, 06:27 AM
Replies: 14
Views: 2,611
Posted By wevie
Why are my batteries getting hot?

My son has a BL Rustler. Using the MM5700. He runs Tenergy 7-cell NiMh packs. I can't say right off the top of my head what the gearing is, but when I put the MM in it, I used the recommended...
Forum: Revo 08.04.2008, 06:20 AM
Replies: 13
Views: 3,742
Posted By wevie
Motor selection for Slayer

I have a 2.5 Revo sitting on the shelf that I haven't fired up for a couple years. Ever since I went BL with my other models, I haven't had any urge to go back to Nitro.

Now that the Slayer is...
Showing results 1 to 11 of 11

 
Forum Jump






Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com

Contact Us - RC-Monster Store - Archive - Top