RC-Monster Forums - View Single Post

MetalMan · 04.16.2007, 11:13 PM

Mine haven't popped off, but have loosened unevenly (at an angle other than perpendicular). This is how bearings have been damaged.

When I pull my motors apart, I just try to keep the rotor from sliding on the windings. But even if I couldn't prevent it, I feel safe about it knowing that there is an epoxy-like coating on the windings that should provide some protection.

	(#19)
MetalMan RC-Monster Mod Offline Posts: 5,297 Join Date: Mar 2005 Location: SoCal	04.16.2007, 11:13 PM Mine haven't popped off, but have loosened unevenly (at an angle other than perpendicular). This is how bearings have been damaged. When I pull my motors apart, I just try to keep the rotor from sliding on the windings. But even if I couldn't prevent it, I feel safe about it knowing that there is an epoxy-like coating on the windings that should provide some protection. SH Z-Car, Custom Crawler, 8s Savage, 12s XTM XLB 1/7 buggy, 4wd 4-link rear/IFS Pro4 truck, Custom Hyper 10 Short Course, Belt-Drive Mammoth ST 1/8 truggy, 4s 17.5 MM Pro HPI Blitz