RC-Monster Forums - View Single Post - Planning Revo V2, to use stock tranny, C. diff and RCM motor mount

Finnster · 04.18.2007, 05:27 PM

2spd? No! Who needs a stinking 2spd w/ BL power? :) 1st will go going out too. The only advantage I see of keeping the 2spd is to be able to overgear a bit for some top end, but I don't think it will be needed, plus I'd rather trade off that for better reliability.

Did you do anything to upgrade that pin, or is it just an expected casualty?

I did see pics of the motors mounted, and I did notice the wires on the top. I couldn't tell from the pics is if the arms would touch the wires when the suspension was fully compressed. Looks like it will clear, so that is good.

So now goes the long process of ordering parts, waiting for backordered stuff, and getting stuff in. Good thing is 1.) I have a truck to play with in the meantime, 2. I should be able to get most of everything from Mike. :)

	(#3)
Finnster KillaHurtz Offline Posts: 2,958 Join Date: Apr 2006 Location: Bucks Co, PA	04.18.2007, 05:27 PM 2spd? No! Who needs a stinking 2spd w/ BL power? :) 1st will go going out too. The only advantage I see of keeping the 2spd is to be able to overgear a bit for some top end, but I don't think it will be needed, plus I'd rather trade off that for better reliability. Did you do anything to upgrade that pin, or is it just an expected casualty? I did see pics of the motors mounted, and I did notice the wires on the top. I couldn't tell from the pics is if the arms would touch the wires when the suspension was fully compressed. Looks like it will clear, so that is good. So now goes the long process of ordering parts, waiting for backordered stuff, and getting stuff in. Good thing is 1.) I have a truck to play with in the meantime, 2. I should be able to get most of everything from Mike. :)