RC-Monster Forums - View Single Post

hyperasus · 04.20.2007, 05:44 AM

Just this week I installed ceramics in all of my Lehner motors(3 1920's and 4 Lehner Basic XL's). The motors run butter smooth now. The main thing I noticed is heat. Before changing the bearings if I touched the motor bearings after a good run then they were hot. Now they stay cool and my motor runs a few degrees cooler as well. From hear an out I don't think I'll even bother with anything but ceramic bearings. They do cost but I think they're worth it. My G3R is going to have the Acer ceramics.

	(#9)
hyperasus RC-Monster Carbon Fiber Offline Posts: 359 Join Date: Feb 2006	04.20.2007, 05:44 AM Just this week I installed ceramics in all of my Lehner motors(3 1920's and 4 Lehner Basic XL's). The motors run butter smooth now. The main thing I noticed is heat. Before changing the bearings if I touched the motor bearings after a good run then they were hot. Now they stay cool and my motor runs a few degrees cooler as well. From hear an out I don't think I'll even bother with anything but ceramic bearings. They do cost but I think they're worth it. My G3R is going to have the Acer ceramics.