RC-Monster Forums - View Single Post - HOW TO: Quark Mod / LSP Conversion *PIC OVERLOAD WARNING*

BrianG · 04.28.2007, 02:51 AM

Well, it probably is just a cap. But it has to have a small value due to the physical size - that's why I said it was for something like low level RF-like filtering. I suppose it could be a resistor or diode, but it doesn't look like it.

As to the solder job, it was either an addendum (therefore soldered by a person), or the traces it attaches to are big enough where the wave solder couldn't grab (acting like a heat sink).

	(#27)
BrianG RC-Monster Admin Offline Posts: 14,609 Join Date: Nov 2005 Location: Des Moines, IA	04.28.2007, 02:51 AM Well, it probably is just a cap. But it has to have a small value due to the physical size - that's why I said it was for something like low level RF-like filtering. I suppose it could be a resistor or diode, but it doesn't look like it. As to the solder job, it was either an addendum (therefore soldered by a person), or the traces it attaches to are big enough where the wave solder couldn't grab (acting like a heat sink).