Quote:
|
Originally Posted by Serum
can you take a pic from above? i'd like to see how the shocks angle is on the felxtek arms. i wasn't too keen on it sitting at an angle..
Looks great man!
Can't wait to see my flm chassis showing up at my doorstep.. :) I might give the FLM shocks a try as well.
|
You are right. The angles are a little undesirable...but there isn't any noticeable binding. I am a little worried about the drive shafts...they are just a hair short and my pivot balls are bottomed out....hmmm. There is room to work though and I think I can figure something out. Maybe put a small bushing on the inside of the knuckle bearing to "push" the dog bone into the drive cup? I would lose a little of the threads for fastening the wheel, but I think there is still enough.
Any Ideas?:032: