RC-Monster Forums - View Single Post

ClodMaxx · 05.04.2007, 10:44 AM

ahhhh, thanks! i knew the rubbing must be something i didn't do right. so the washer needs to go in between the 2 bearings, or just on the outside of the outer bearing (in between the outer bearing and the hex)?

i guess i'll have to get an order in for the UE ext cvd's. i also plan to get a UE titanium dogbone to replace the (too short) dogbone that comes with the FLM chassis. anyone know if this size is 100.5mm, or 105mm?

thanks again mattymaxx!

	(#15)
ClodMaxx hold my beer... watch this... Offline Posts: 969 Join Date: Feb 2007 Location: berkley, michigan	05.04.2007, 10:44 AM ahhhh, thanks! i knew the rubbing must be something i didn't do right. so the washer needs to go in between the 2 bearings, or just on the outside of the outer bearing (in between the outer bearing and the hex)? i guess i'll have to get an order in for the UE ext cvd's. i also plan to get a UE titanium dogbone to replace the (too short) dogbone that comes with the FLM chassis. anyone know if this size is 100.5mm, or 105mm? thanks again mattymaxx! Xray XT8 (Neu powered) MMM on 5s MD 500 scale heli - castle HV-45 on 3s Eflite Blade 400 heli on 3s