RC-Monster Forums - View Single Post - XTM X-Terminator BL and Lipo 1/8 Buggy

MetalMan · 07.07.2005, 05:14 PM

I think the second part is in fact a surface mount resistor. I think it is possible that the controller got hot enough that it melted the solder on it slightly, and then it got knocked off by the jump. If I had to take a guess, I would think that the part is this one:
http://www.mouser.com/index.cfm?hand...oductid=313900
The first one is so badly broken that I can't tell what it is. And I would definately rather replace it than send it to BK and wait mroe than a month (don't have that kind of time).

	(#11)
MetalMan RC-Monster Mod Offline Posts: 5,297 Join Date: Mar 2005 Location: SoCal	07.07.2005, 05:14 PM I think the second part is in fact a surface mount resistor. I think it is possible that the controller got hot enough that it melted the solder on it slightly, and then it got knocked off by the jump. If I had to take a guess, I would think that the part is this one: http://www.mouser.com/index.cfm?hand...oductid=313900 The first one is so badly broken that I can't tell what it is. And I would definately rather replace it than send it to BK and wait mroe than a month (don't have that kind of time). SH Z-Car, Custom Crawler, 8s Savage, 12s XTM XLB 1/7 buggy, 4wd 4-link rear/IFS Pro4 truck, Custom Hyper 10 Short Course, Belt-Drive Mammoth ST 1/8 truggy, 4s 17.5 MM Pro HPI Blitz