RC-Monster Forums - View Single Post

zeropointbug · 10:08 PM

I sent mine off to S&T, they said they would just replace it, no questions. The electrolyte would have damaged the board, as well as when there are no caps, there would have been damage done to the board.

I have a really good plan for a custom Quark case, I just need the distance from bottom FET surface to top FET surface. It will be about 1cm wider than the stock case though.

It will not need adhesive either, just regular thermal compound, which is nice.

	(#3)
zeropointbug Z-Pinch racer Offline Posts: 3,141 Join Date: Nov 2006 Location: SK, Canada	05.09.2007, 10:07 PM I sent mine off to S&T, they said they would just replace it, no questions. The electrolyte would have damaged the board, as well as when there are no caps, there would have been damage done to the board. I have a really good plan for a custom Quark case, I just need the distance from bottom FET surface to top FET surface. It will be about 1cm wider than the stock case though. It will not need adhesive either, just regular thermal compound, which is nice. “The modern astrophysical concept that ascribes the sun’s energy to thermonuclear reactions deep in the solar interior is contradicted by nearly every observable aspect of the sun.” —Ralph E. Juergens Last edited by zeropointbug; 05.09.2007 at 10:08 PM.