RC-Monster Forums - View Single Post

zeropointbug · 05.12.2007, 10:27 PM

oh oh oh, no no, there will be no epoxy to be had in this case, just thermal paste, arctic silver. It does clamp the board, so you don't need/want epoxy, and you can always take it apart too.

I have to get the distance right between the two plates, as to get a good pressure (but not too much) on the FET's for good coupling.

I am just modifying it right now, with heatsink bottom, and motor mount holes. It should be good.

Thanks Mach1stang! :027:

	(#10)
zeropointbug Z-Pinch racer Offline Posts: 3,141 Join Date: Nov 2006 Location: SK, Canada	05.12.2007, 10:27 PM oh oh oh, no no, there will be no epoxy to be had in this case, just thermal paste, arctic silver. It does clamp the board, so you don't need/want epoxy, and you can always take it apart too. I have to get the distance right between the two plates, as to get a good pressure (but not too much) on the FET's for good coupling. I am just modifying it right now, with heatsink bottom, and motor mount holes. It should be good. Thanks Mach1stang! :027: “The modern astrophysical concept that ascribes the sun’s energy to thermonuclear reactions deep in the solar interior is contradicted by nearly every observable aspect of the sun.” —Ralph E. Juergens