RC-Monster Forums - View Single Post

zeropointbug · 08:16 PM

Yeah, me too. I think it's best keeping to one design, and integral is my middle name.

This is what an R/C MT esc should be with this heatsink, the Quark... even if S&T made the top set of FET's coupled to the chassis, that would be worlds better.

CAD program says the outside surface area is roughly 300cm2. That should do the trick. :017:

So maxxman, nieles, ssspconcepts, patrick, A4DTM, jhautz are you guys seriously interested in getting one for yourselves?

Again, the design is not to specs, I don't have my Quark back yet from S&T, so it's going to have to wait for it to get here.

Does anyone happen to know a free thermal simulator program that I could use on this case?

ZPB

	(#37)
zeropointbug Z-Pinch racer Offline Posts: 3,141 Join Date: Nov 2006 Location: SK, Canada	05.17.2007, 08:05 PM Yeah, me too. I think it's best keeping to one design, and integral is my middle name. This is what an R/C MT esc should be with this heatsink, the Quark... even if S&T made the top set of FET's coupled to the chassis, that would be worlds better. CAD program says the outside surface area is roughly 300cm2. That should do the trick. :017: So maxxman, nieles, ssspconcepts, patrick, A4DTM, jhautz are you guys seriously interested in getting one for yourselves? Again, the design is not to specs, I don't have my Quark back yet from S&T, so it's going to have to wait for it to get here. Does anyone happen to know a free thermal simulator program that I could use on this case? ZPB “The modern astrophysical concept that ascribes the sun’s energy to thermonuclear reactions deep in the solar interior is contradicted by nearly every observable aspect of the sun.” —Ralph E. Juergens Last edited by zeropointbug; 05.17.2007 at 08:16 PM.