Quote:
|
Originally Posted by zeropointbug
Well, I got my Quark back today, surprisingly fast. :003:
It is raining today, so no running. I took it apart and tried to look at the capacitor markings.... the brand looks like it's 'SANNHA' 'WB' series. I have never heard of that brand, and I can not find a SINGLE thing searching for it.
I think S&T are having trouble with 'Quality Control', my new Quark has a few near cold solders. And the caps have burn marks all around from soldering them on. The middle motor wire does not have solder on the top half of the pcb, not good.
So I was pretty dang close as far as guessing the measurements for my custom quark case. Only .5 - 1mm off hear and there.
I will fix all measurements and post a screenie of the quark case.
|
Perhaps there has been an increase in popularity for the Quark controllers and they are having trouble meeting demand?