RC-Monster Forums - View Single Post - My E-Revo w/ Custom chassis and solid center gear

jeeperscreapers · **My E-Revo w/ Custom chassis and solid center gear -** 06.01.2007, 06:13 PM

Hello everyone, this is my first post on this forum!!!!!

I checked out most of you guys e-revo's and I have to say that I havent seen one yet that did'nt impress me :) So I decided I'd share some pics of my E-Revo!!!

My goal for my E-revo was MASSIVE speed and a truggy like chassis. I custom made my upper and lower chassis along with everything else pictured. The only parts I was unable to make were the dogbones, cups, motor mount, and shock mounts..... As for the POWER!!!! I'm running a 14 cell IB4200 WCE pack, BK Warrior 9920, and the Feigao 8L with a 12t pinion and 96t steel spur. I've heard on different forums that the 8L is a bit small, BUT it's more than enough power for me. It has more low end power than I can possibly handle. As far as top speed...... I can run side by side with a car going 50mph. So I think it is safe to say it will go ATLEAST 40mph :) . It does run a little warm but not bad at all, ESPECIALLY since I haven't gotten my motor heatsink or my esc fan yet :)

Please leave me some feedback and advice on what you guys think!!!!! Lookin forward to hearing your comments, I'm even ready for some constructive criticism :P

Thx!!!

	(#1)
jeeperscreapers RC-Monster Stock Offline Posts: 10 Join Date: Jun 2007	My E-Revo w/ Custom chassis and solid center gear - 06.01.2007, 06:13 PM Hello everyone, this is my first post on this forum!!!!! I checked out most of you guys e-revo's and I have to say that I havent seen one yet that did'nt impress me :) So I decided I'd share some pics of my E-Revo!!! My goal for my E-revo was MASSIVE speed and a truggy like chassis. I custom made my upper and lower chassis along with everything else pictured. The only parts I was unable to make were the dogbones, cups, motor mount, and shock mounts..... As for the POWER!!!! I'm running a 14 cell IB4200 WCE pack, BK Warrior 9920, and the Feigao 8L with a 12t pinion and 96t steel spur. I've heard on different forums that the 8L is a bit small, BUT it's more than enough power for me. It has more low end power than I can possibly handle. As far as top speed...... I can run side by side with a car going 50mph. So I think it is safe to say it will go ATLEAST 40mph :) . It does run a little warm but not bad at all, ESPECIALLY since I haven't gotten my motor heatsink or my esc fan yet :) Please leave me some feedback and advice on what you guys think!!!!! Lookin forward to hearing your comments, I'm even ready for some constructive criticism :P Thx!!!