RC-Monster Forums - View Single Post

_paralyzed_ · **thanks serum! -** 06.03.2007, 10:10 AM

This site is a wealth of knowledge but i'm stuck, my esc is fresh back from hacker, my motor is brand new from fine designs, it worked out of the truck but in the truck nothing. The idiot putting it in ground over a third of my shaft away to make a flat spot for the set screw, could that have got the motor too hot? the wiring looks like a zig zag pattern and I just can't solder and do wiring from my wheelchair, is there anyone in minnesota that can give me a hand?

	(#3)
_paralyzed_ working on a brushless for my wheelchair..... Offline Posts: 4,890 Join Date: Mar 2007 Location: minnesnowta	thanks serum! - 06.03.2007, 10:10 AM This site is a wealth of knowledge but i'm stuck, my esc is fresh back from hacker, my motor is brand new from fine designs, it worked out of the truck but in the truck nothing. The idiot putting it in ground over a third of my shaft away to make a flat spot for the set screw, could that have got the motor too hot? the wiring looks like a zig zag pattern and I just can't solder and do wiring from my wheelchair, is there anyone in minnesota that can give me a hand?