RC-Monster Forums - View Single Post

BrianG · 06.03.2007, 05:12 PM

Definitely! Without lok-tite, the screws back out pretty quickly. It takes about 10 minutes to loosen on a steel on steel setup. It lasts longer on a steel pinion/plastic spur setup, but still backs out. It's funny though; I've never used lok-tite on the Jato and it runs fine, but the Revo needs it. And I put about the same amount of tightening force on both (so the wrench twists about half a turn, lol). Go figure.

	(#34)
BrianG RC-Monster Admin Offline Posts: 14,609 Join Date: Nov 2005 Location: Des Moines, IA	06.03.2007, 05:12 PM Definitely! Without lok-tite, the screws back out pretty quickly. It takes about 10 minutes to loosen on a steel on steel setup. It lasts longer on a steel pinion/plastic spur setup, but still backs out. It's funny though; I've never used lok-tite on the Jato and it runs fine, but the Revo needs it. And I put about the same amount of tightening force on both (so the wrench twists about half a turn, lol). Go figure.