O.K. I've been out of town unexpectedly, so....


Zeropointbug- Do you still want the quark I killed????

I have read somewhere that having extra CAPS only works good if they are "on top of" the FETS- I also read somewhere that it is BAD to have the CAPS "very far from" the FETS. (something about extra resistance - I dont remember) These were posts from consumers, nothing official...

I put 4 caps directly on my board where the other 2 caps connect. (1 next to and 3 across from. yes they stick out the side...) I replaced the sticky pads with thermal epoxy, and epoxied the case to the rcmonster heatsink (no fan but it is connected to the chassis and gets good air flow)

I just set up my new NEU 1512 2.5D smooth can with a 6200 5S4P maxamps in my 8ight buggy with 13/46 - the quark setting are all hot (Its a bit jumpy, I'll probly soften the torque)

I ran it HARD and FAST (faster then that buggy has ever been) for about 30 min - Motor = 165* or so, Batteries = 110*, Quark = 145* (it was 94* weather)

Some tuning and a motor heatsink will only make it better!!:017: