|
06.08.2007, 06:00 PM
What epoxy did you use then?
The heat build up on the tep FET's... like I said, any power bursts will have a larger temp differential than the average temp difference, so higher thermal transfer the better. But it is harder to do the top set i guess. The best way would to just use the case I designed really. You just apply thermal paste, and slide in on and clamp her down, there goes all heat sources down the sink. :005: HEAT sink that is.
“The modern astrophysical concept that ascribes the sun’s energy to thermonuclear reactions deep in the solar interior is contradicted by nearly every observable aspect of the sun.” —Ralph E. Juergens
|