RC-Monster Forums - View Single Post

Nick · **MIP CVDs -** 07.14.2005, 02:17 PM

I have the MIP Pro-Line CVDs and very proud of them.

However, the cup that is connected to the differential outputs is fastened by grip using 2 little hex-grub type screws.

They keep coming lose and I would of thought a small pin would go through the outputs rather than this grip technique.

Any ways of making them hold strong? Or a DIY method of holding it another way?

	(#1)
Nick COOKIES! Offline Posts: 1,310 Join Date: Mar 2005 Location: England, York	MIP CVDs - 07.14.2005, 02:17 PM I have the MIP Pro-Line CVDs and very proud of them. However, the cup that is connected to the differential outputs is fastened by grip using 2 little hex-grub type screws. They keep coming lose and I would of thought a small pin would go through the outputs rather than this grip technique. Any ways of making them hold strong? Or a DIY method of holding it another way? ~ Nick.