RC-Monster Forums - View Single Post

NiCad · 10:20 PM

I got a 7" buffer wheel set up. I polished this up. Two passes on the cutting side and two on the polish. I plan to spend a little more time with it and the most likely have the dremel on the back side to finish it up.

Got the Battery mount laid out. I plan to do the machining this week(end). Then polish it as well.

looking into making a hold down mount. Attached is a rough sketch. I was thinking these would be pretty trick. Mount at top and back. Bottom is not for sure. I hate drilling holes in the chassis. Plan to to do four of them for the battery mount plate.

If I do not attach the hold downs to the chassis I prob lose that leg all together and have a L bracket so to speak.

Any ideas or things you see that might not work please do not be shy.

Thanks,
NiCad

	(#29)
NiCad R/C Racer Offline Posts: 45 Join Date: May 2007 Location: IN	06.25.2007, 10:18 PM I got a 7" buffer wheel set up. I polished this up. Two passes on the cutting side and two on the polish. I plan to spend a little more time with it and the most likely have the dremel on the back side to finish it up. Got the Battery mount laid out. I plan to do the machining this week(end). Then polish it as well. looking into making a hold down mount. Attached is a rough sketch. I was thinking these would be pretty trick. Mount at top and back. Bottom is not for sure. I hate drilling holes in the chassis. Plan to to do four of them for the battery mount plate. If I do not attach the hold downs to the chassis I prob lose that leg all together and have a L bracket so to speak. Any ideas or things you see that might not work please do not be shy. Thanks, NiCad Attached Thumbnails Owens Racing™ CRT.5 B/L Detta ST B/L RC18(diggity LHO) B/L Detta Buggies Brushed Bashers Last edited by NiCad; 06.25.2007 at 10:20 PM.