RC-Monster Forums - View Single Post - A123 Hypersonic Charger Balancing/connector

brijar · 08.24.2007, 06:42 PM

No, the Hypersonic charger charges 3.3v M1 cells to a full charged state of 3.6v, but they drop back down to 3.3v very quickly and remain there till almost the very end of the charge.

As far as capacity goes, it will charge any capacity until it reaches 3.6 volts per cell, up to 3 cells.

The Dewalt cells are the same ratings as the A123 Racing cells, but they may be lower quality units. Sometimes you may get a bad cell in a Dewalt pack that doesn't hold full charge voltage or capacity.

Brijar!!!

	(#27)
brijar Knowing You're Hooked on RC: Priceless... Offline Posts: 271 Join Date: Feb 2006 Location: Blue Springs (KC) MO	08.24.2007, 06:42 PM No, the Hypersonic charger charges 3.3v M1 cells to a full charged state of 3.6v, but they drop back down to 3.3v very quickly and remain there till almost the very end of the charge. As far as capacity goes, it will charge any capacity until it reaches 3.6 volts per cell, up to 3 cells. The Dewalt cells are the same ratings as the A123 Racing cells, but they may be lower quality units. Sometimes you may get a bad cell in a Dewalt pack that doesn't hold full charge voltage or capacity. Brijar!!! REVO 3.3 Conversion: 3906 trans, CC 1518, MMM, 6s Gens Ace 5k 40C, LST Diffs, Summit shafts Slash 2x4 LCG Two Slash 4x4s Rustler