RC-Monster Forums - View Single Post

What's_nitro? · **Brushless EDF Tamiya F103GT -** 08.25.2007, 10:39 PM

Hi everyone, it's nice to have the old forum back again. Anyways here are some pictures of the new fan I bought.

Now that I've seen it next to the car, it's bigger than I thought. It will still work though.

Some chassis trimming:

Compared to a Great Planes HyperFlow EDF:

It's big:

Really big!:

I ordered a set of 12mm-12mm TLT axle extensions which will make it 3 inches wider in the rear. Also, the power system has changed. I will no longer be using my old Lehner XL 5000 because the rotor adapter is 5mm only. So- I'm getting a Feigao 8xl. I have some 4s 2200mAH LiPo packs from my HV Maxx setup that I'll use in parallel until I can afford new, higher capacity, packs. I have a BK 12020 to use as well.

	(#1)
What's_nitro? Soldermaster Extraordinaire Offline Posts: 4,529 Join Date: Apr 2007 Location: Plymouth, MA, USA	Brushless EDF Tamiya F103GT - 08.25.2007, 10:39 PM Hi everyone, it's nice to have the old forum back again. Anyways here are some pictures of the new fan I bought. Now that I've seen it next to the car, it's bigger than I thought. It will still work though. Some chassis trimming: Compared to a Great Planes HyperFlow EDF: It's big: Really big!: I ordered a set of 12mm-12mm TLT axle extensions which will make it 3 inches wider in the rear. Also, the power system has changed. I will no longer be using my old Lehner XL 5000 because the rotor adapter is 5mm only. So- I'm getting a Feigao 8xl. I have some 4s 2200mAH LiPo packs from my HV Maxx setup that I'll use in parallel until I can afford new, higher capacity, packs. I have a BK 12020 to use as well.