RC-Monster Forums - View Single Post

lutach · 09.08.2007, 12:22 PM

That happened to my 8012-3s. All I did was start the programming sequence. I first held full throttle and waited for the beeps and then full brake after the beeps. I then applied full throttle for each mode until it was over. That seemed to restore my full throttle and full brake and the controller worked fine. Afterwards I did the programming again to set it parameters that I wanted.

	(#4)
lutach RC-Monster Dual Brushless Offline Posts: 5,139 Join Date: Sep 2006	09.08.2007, 12:22 PM That happened to my 8012-3s. All I did was start the programming sequence. I first held full throttle and waited for the beeps and then full brake after the beeps. I then applied full throttle for each mode until it was over. That seemed to restore my full throttle and full brake and the controller worked fine. Afterwards I did the programming again to set it parameters that I wanted.