Well, that 1500w estimate was generous. I typically use between a 6x-7x multiplier and it usually works out very close. 9.2A x 7 = 64.4A burst. That makes 1487w, but that's assuming the voltage is 3.3v/cell, which I'm sure is not the case. Assuming the 7x multiplier is right, 1300w would equate to about 2.8v/cell under that load. Is that about right?
I'm curious because I still want to make that runtime calculator/lipo selector page for my site and
need all the sample data I can get. BTW: Could you post your eagletree results in that thread? It would help a lot.