[bdebde]

I finally got a chance to try my 16024 today, though not for long. Seems I am having similar issues. Running a Big MAXXimum on 6s puts me at about 50,000rpm too. Running in "cut off" mode it cuts out if I accelerate hard, Running in "reduce rpm" mode was better, but did cut out some as well. Running in "race" mode worked great, but after about 5 min it cut out, so I figured I better stop since I had about 15 min running on the batts with no lvc. I think the issue is current protection kicking in, the controller software on the computer said a max amps of 400! However, it does not seem to log amps in "race" mode, at least on my one run. My batts are hardly even warming up at all, which seems weird if it is going that high in amps or if the voltage is in fact dropping below the 3.1v cut off that often. I ran about 5min in each mode, so further running is needed to see just what is going on. And FYI, max temp reported in the software was 56c, so it is not thermalling (I would hope).