RC-Monster Forums - View Single Post

MetalMan · 09.28.2007, 12:09 AM

There's another way to go about this - you're going to need to make a custom shaft for the outrunner as it is, so when you make the shaft, you can make it (or have it made) such that it will be the proper length for the dogbones to fit into the output cups.

	(#3)
MetalMan RC-Monster Mod Offline Posts: 5,297 Join Date: Mar 2005 Location: SoCal	09.28.2007, 12:09 AM There's another way to go about this - you're going to need to make a custom shaft for the outrunner as it is, so when you make the shaft, you can make it (or have it made) such that it will be the proper length for the dogbones to fit into the output cups. SH Z-Car, Custom Crawler, 8s Savage, 12s XTM XLB 1/7 buggy, 4wd 4-link rear/IFS Pro4 truck, Custom Hyper 10 Short Course, Belt-Drive Mammoth ST 1/8 truggy, 4s 17.5 MM Pro HPI Blitz