RC-Monster Forums - View Single Post - Savage brushless conversion ... another one

helms · 10.01.2007, 10:13 AM

well, there is no thread telling how long the drive shafts have to be... this is your decision ... you decide where you put your motor.

I did not like to have the batteries outside the TVPs, I wanted to have them inside the chassis, so I had to push the motor to the rear, the batteries to the front. As the motor is close to the rear differential, the drive shaft got short... and to the front it passes along the batteries, so it got long. I just measured the length I needed, and Mike fabricated the drive shafts (very well) (thanks again to Mike!!!)

	(#13)
helms BL-Monster Savage Offline Posts: 17 Join Date: Apr 2007 Location: FR-CH-GER	10.01.2007, 10:13 AM well, there is no thread telling how long the drive shafts have to be... this is your decision ... you decide where you put your motor. I did not like to have the batteries outside the TVPs, I wanted to have them inside the chassis, so I had to push the motor to the rear, the batteries to the front. As the motor is close to the rear differential, the drive shaft got short... and to the front it passes along the batteries, so it got long. I just measured the length I needed, and Mike fabricated the drive shafts (very well) (thanks again to Mike!!!)