RC-Monster Forums - View Single Post

highflier · **brushless and A123 questions -** 10.13.2007, 09:49 PM

Hey all,
I tried out my E-maxx today with new Batteries, I was really hoping for a big boost from my previous packs. (6c 3300's) for 14.4 Volts

I was disappointed in the performance gain. Seemed kinda minimal improvement. My setup is as follows

wanderer 9XL
BK 12020 controller
Big Joe Tires
Forget the exact tooth on the pinion, I think it is 15.
A123 6s1p. (20 Volts)
Everything else is stock.

Now for the questions.
1) Do I need to go to a 6s2p pack??
2) What chassis would fit these packs and work good for bashing? (Packs are 3s side by side. I put one pack on each side of the stock chassis even though it did not fit...... (Had to rig it temporarly to test)
3) I am thinking about smaller tires.. Maybe the proline mulchers 40 series and some of the axial bead less rims. Would tha be a good set up?
4) What else is really needed for Bashing... Steering upgrade?

Highflier

	(#1)
highflier Emaxx- FLM wannabe Offline Posts: 253 Join Date: Oct 2005 Location: PA	brushless and A123 questions - 10.13.2007, 09:49 PM Hey all, I tried out my E-maxx today with new Batteries, I was really hoping for a big boost from my previous packs. (6c 3300's) for 14.4 Volts I was disappointed in the performance gain. Seemed kinda minimal improvement. My setup is as follows wanderer 9XL BK 12020 controller Big Joe Tires Forget the exact tooth on the pinion, I think it is 15. A123 6s1p. (20 Volts) Everything else is stock. Now for the questions. 1) Do I need to go to a 6s2p pack?? 2) What chassis would fit these packs and work good for bashing? (Packs are 3s side by side. I put one pack on each side of the stock chassis even though it did not fit...... (Had to rig it temporarly to test) 3) I am thinking about smaller tires.. Maybe the proline mulchers 40 series and some of the axial bead less rims. Would tha be a good set up? 4) What else is really needed for Bashing... Steering upgrade? Highflier