RC-Monster Forums - View Single Post

sikeston34m · 10.18.2007, 06:15 PM

Hey ZP. I hope you can get your controller going again. That sure was an awesome setup.

On the brain board, I think I would see if I could clean off that fet "residue". That stuff is probably conductive and could give you problems even if the underlying components are good.

Good Luck with this project.

	(#3)
sikeston34m RC-Monster Brushless Offline Posts: 2,085 Join Date: Sep 2007	10.18.2007, 06:15 PM Hey ZP. I hope you can get your controller going again. That sure was an awesome setup. On the brain board, I think I would see if I could clean off that fet "residue". That stuff is probably conductive and could give you problems even if the underlying components are good. Good Luck with this project.