RC-Monster Forums - View Single Post

Patrick · 10.23.2007, 04:03 AM

Yes, the top and bottom plates bend to the angle of the bulk.
Doesn't sound right, but I've been accidentally trying to break it and I haven't succeeded yet.
Only problem is that it's not extended, and since the bottom plate goes the full length of the car I don't see how you could fit the mono block extension on it.

	(#35)
Patrick RC-Monster Aluminum Offline Posts: 862 Join Date: Dec 2006 Location: Perth, Western Australia	10.23.2007, 04:03 AM Yes, the top and bottom plates bend to the angle of the bulk. Doesn't sound right, but I've been accidentally trying to break it and I haven't succeeded yet. Only problem is that it's not extended, and since the bottom plate goes the full length of the car I don't see how you could fit the mono block extension on it.