RC-Monster Forums - View Single Post

glassdoctor · 10.24.2007, 10:18 PM

I have bent mine 90* but as mentioned... I would not reccomend repeated bends back and forth. I have bent mine back a couple times when I swapped vehicles, etc. But I don't like doing that.

Neu does also say to not put a lot of stress on the wires, to prevent damage to the windings. Just a general caution... so keep that in mind when bending them. I used a pair of needle nose to hold the wire close to the can, rather than just bending them without any support.

	(#8)
glassdoctor TEAM FUSION Offline Posts: 2,041 Join Date: Jul 2006 Location: Iowa... Hawkeye country	10.24.2007, 10:18 PM I have bent mine 90* but as mentioned... I would not reccomend repeated bends back and forth. I have bent mine back a couple times when I swapped vehicles, etc. But I don't like doing that. Neu does also say to not put a lot of stress on the wires, to prevent damage to the windings. Just a general caution... so keep that in mind when bending them. I used a pair of needle nose to hold the wire close to the can, rather than just bending them without any support. Jammin CRT MM/Neu 1515 1700kv Losi 8IGHT MM/Neu 1512 1900kv Kyosho 777 T4 MM 5700 B4 LRP XX4 MM 7700 old losi xxcr, MM4600 4s lipo 70mph+