|
08.05.2005, 10:29 PM
To do anything cheaper, you would pretty much have to contact someone in the UK. I could do it, assumining I could find the right size aluminum angle, and if I had mounting dimensions. But the shipping cost would make it not worth it. Also, shipping would take a little while to get from California to the UK.
If I were to do it, and found a good piece of aluminum angle, I would probably charge ~$25USD without shipping. This wouldn't be ideal though, unless you are willing to wait a week and a half since I am leaving to go on vacation on Tuesday.
SH Z-Car, Custom Crawler, 8s Savage, 12s XTM XLB 1/7 buggy, 4wd 4-link rear/IFS Pro4 truck, Custom Hyper 10 Short Course, Belt-Drive Mammoth ST 1/8 truggy, 4s 17.5 MM Pro HPI Blitz
|