RC-Monster Forums - View Single Post

RC-Monster Mike · 08.10.2005, 10:50 PM

The Strobe slipper is the best available, but matching that low ratio would be pretty tough(requires an 8.5 tooth pinion, which is too small for a mod1 pinion due to the larger teeth). I carry mod1 pinions as small as a 10 tooth, and could get a bore reducer to make it fit the HV maxx motor shafts(1/8"). The slipper comes with the needed pads, and uses the stock spring and pressure plates. Only 4 additional 3mm screws would be needed to mount the ofna spur gear to it.

	(#16)
RC-Monster Mike Site Owner Offline Posts: 4,915 Join Date: Nov 2004 Location: PA	08.10.2005, 10:50 PM The Strobe slipper is the best available, but matching that low ratio would be pretty tough(requires an 8.5 tooth pinion, which is too small for a mod1 pinion due to the larger teeth). I carry mod1 pinions as small as a 10 tooth, and could get a bore reducer to make it fit the HV maxx motor shafts(1/8"). The slipper comes with the needed pads, and uses the stock spring and pressure plates. Only 4 additional 3mm screws would be needed to mount the ofna spur gear to it.