RC-Monster Forums - View Single Post

GriffinRU · **MambaMax Mod 2 -** 11.18.2007, 02:55 PM

Sanding FET's for better adhesion and flatness
Silver epoxy Top side of middle Fet's board
Silver epoxy Bottom side of middle Fet's board
Attach brass heatsink to top and bottom (Remove LED's)
Solder Header to Top Fet's Board
Solder new Caps to Top Fet's Board
Check alignment of top and middle boards
Apply heatsink grease to bottom Fet's of Top Fet's board
Solder headers and caps, trim caps leads
Attach brains pcb, trim header
Prefinal view

Further steps will follow...

To suicideneil:
Why using bad motor when you can utilize better one, have you checked my thread about 7XL running on sensored mode, borrowing sensors from HV-Maxx motor?

	(#160)
GriffinRU RC-Monster Aluminum Offline Posts: 748 Join Date: Oct 2005	MambaMax Mod 2 - 11.18.2007, 02:55 PM Sanding FET's for better adhesion and flatness Silver epoxy Top side of middle Fet's board Silver epoxy Bottom side of middle Fet's board Attach brass heatsink to top and bottom (Remove LED's) Solder Header to Top Fet's Board Solder new Caps to Top Fet's Board Check alignment of top and middle boards Apply heatsink grease to bottom Fet's of Top Fet's board Solder headers and caps, trim caps leads Attach brains pcb, trim header Prefinal view Further steps will follow... To suicideneil: Why using bad motor when you can utilize better one, have you checked my thread about 7XL running on sensored mode, borrowing sensors from HV-Maxx motor?