RC-Monster Forums - View Single Post - Aluminum Battery Tray [BEWARE LARGE PICS]

skillx · 08:40 PM

I had some time this holiday weekend to put some time in on the 8. Here are a few shots of the changes.

1) I went away from the RX pack and switched to a ubec.
2) I added a RCM heatsink and 2 40mm fans to the Quark. Mounting is still throwing me for a loop so I am doing the zip tie thing on the center diff until something else looks better. I did see a mount somewhere that hung the ESC off the back of the center diff mount but can't seem to remember where i saw it.
3) Modified my battery tray a little and added foam to the bottom. Also drilled some holes for venting and adding zip ties for racing.
4) The body was painted by the original owner of the roller i bought but I added some RCM stickers which did WONDERS for it.

Here it be....

	(#11)
skillx RC-Monster Carbon Fiber Offline Posts: 72 Join Date: Aug 2007 Location: TEXAS BABY!	11.25.2007, 08:38 PM I had some time this holiday weekend to put some time in on the 8. Here are a few shots of the changes. 1) I went away from the RX pack and switched to a ubec. 2) I added a RCM heatsink and 2 40mm fans to the Quark. Mounting is still throwing me for a loop so I am doing the zip tie thing on the center diff until something else looks better. I did see a mount somewhere that hung the ESC off the back of the center diff mount but can't seem to remember where i saw it. 3) Modified my battery tray a little and added foam to the bottom. Also drilled some holes for venting and adding zip ties for racing. 4) The body was painted by the original owner of the roller i bought but I added some RCM stickers which did WONDERS for it. Here it be.... Last edited by skillx; 11.25.2007 at 08:40 PM.