|
11.27.2007, 04:25 PM
Well...
You could give it a try on 11.1v (3s lipo), 14.8 (4s) will spin the motor too fast and cause alot of heat. You can get a 9t pinion from century and use one of mike's bore reducers so that it will fit on the 1/8 shaft of the 4600. With 40/9 gearing it would top out at 30mph in 2nd gear, so it may be ok. Here is the copy of briang's speed calc so that you can see what I used to get the numbers:
Differential Ratio: 2.8461538461538462
Transmission Ratio: 2.2941176470588233
Other Ratio: 1
Spur Tooth Count: 40
Pinion Tooth Count: 9
Total Voltage: 11.1
Motor KV: 4600
Tire Diameter (inches): 5.75
Tire Ballooning (inches): 0
Motor Current Draw: 0
Motor coil Ω: 0
Spur/Pinion Ratio: 4.44 : 1
Total Ratio: 29.01961 : 1
Tire Circumference (inches): 18.06 inches (458.83mm)
Total Motor Speed: 51060 RPM
Vehicle Speed: 30.1 MPH (48.35km/h)
Effective Speed Rate: 2.71mph/V (4.36kmh/V)
Effective KV Value: 4600
Motor Torque: Amperage not specified...
Final Torque: Amperage not specified...
|