RC-Monster Forums - View Single Post

sikeston34m · 12.03.2007, 07:21 PM

Well the custom wind from the manufacturer is pretty much out of the picture. I can buy two regular motors for what they want for that.

I have a second 4130/20 here that I can use to experiment with different windings. But how do I get this stator off the bearing holder?

Hmmm, I wonder if I could trim the stationary endbell down to allow enough room to do the winding and make the terminations?

I was thinking about modifying a pair of needle nose pliers to aid me in this. Grind the teeth off the jaws, then wrap them with black tape. I know I can't tear the insulation on the winding wire as this will create shorts.

	(#227)
sikeston34m RC-Monster Brushless Offline Posts: 2,085 Join Date: Sep 2007	12.03.2007, 07:21 PM Well the custom wind from the manufacturer is pretty much out of the picture. I can buy two regular motors for what they want for that. I have a second 4130/20 here that I can use to experiment with different windings. But how do I get this stator off the bearing holder? Hmmm, I wonder if I could trim the stationary endbell down to allow enough room to do the winding and make the terminations? I was thinking about modifying a pair of needle nose pliers to aid me in this. Grind the teeth off the jaws, then wrap them with black tape. I know I can't tear the insulation on the winding wire as this will create shorts.