RC-Monster Forums - View Single Post

sikeston34m · 12.09.2007, 10:38 PM

Hey Linc,

The clutch is an idea if you can come up with the mechanical aspects of it. Design I mean. It's a tradeoff since you have to use mechanical brakes though. Just remember, down on the center driveshaft there is MUCH higher torque and higher gearing.

Hey Metalman,

LOL@Crow screaming. That's gotta be strange.

I've never tried an outrunner on 10S A123. I have tried an E maxx Outrunner setup on 6S2P A123 which resulted in stripping the hole in the tranny drive dog. I wasn't jumping or anything. It was from HARD acceleration with a 715kv 3530 5 turn.

Sounds like High Timing works good on that setup.

Can you get us a video of this thing?

	(#50)
sikeston34m RC-Monster Brushless Offline Posts: 2,085 Join Date: Sep 2007	12.09.2007, 10:38 PM Hey Linc, The clutch is an idea if you can come up with the mechanical aspects of it. Design I mean. It's a tradeoff since you have to use mechanical brakes though. Just remember, down on the center driveshaft there is MUCH higher torque and higher gearing. Hey Metalman, LOL@Crow screaming. That's gotta be strange. I've never tried an outrunner on 10S A123. I have tried an E maxx Outrunner setup on 6S2P A123 which resulted in stripping the hole in the tranny drive dog. I wasn't jumping or anything. It was from HARD acceleration with a 715kv 3530 5 turn. Sounds like High Timing works good on that setup. Can you get us a video of this thing?