RC-Monster Forums - View Single Post

MetalMan · 08.23.2005, 11:17 AM

Gustav, you have a good idea with that. (an extended bearing thingy). To me, that seems like somethat that could only be made on a lathe. It would require a large nut too! (~3/8"). So basically, all that is needed is a back plate for a differential that would have an extended bearing mount, that would be cut on a lathe. I will try to design this piece on Solidworks.

	(#32)
MetalMan RC-Monster Mod Offline Posts: 5,297 Join Date: Mar 2005 Location: SoCal	08.23.2005, 11:17 AM Gustav, you have a good idea with that. (an extended bearing thingy). To me, that seems like somethat that could only be made on a lathe. It would require a large nut too! (~3/8"). So basically, all that is needed is a back plate for a differential that would have an extended bearing mount, that would be cut on a lathe. I will try to design this piece on Solidworks. SH Z-Car, Custom Crawler, 8s Savage, 12s XTM XLB 1/7 buggy, 4wd 4-link rear/IFS Pro4 truck, Custom Hyper 10 Short Course, Belt-Drive Mammoth ST 1/8 truggy, 4s 17.5 MM Pro HPI Blitz