RC-Monster Forums - View Single Post

DrKnow65 · 01.12.2008, 02:55 AM

Just resurected mustbnitro's dead MM

Long story short, the solder from one of the caps was touching one of the buss leads. It actually had 12 burnt fet's and 2 that were cracked from taking the heat sink off. It has a few lifted traces and 3 of the copper sleeves that interconnect the pcb were pulled out so it took a little creative soldering.

I didn't keep the mod though, didn't want to spend the time if it wasn't going to work and I'm not taking it apart again to try. So at this point it just has the better caps, diode, and deans wet noodle wire. Think I'll attach a fan and call it good.

	(#51)
DrKnow65 RC-Monster Aluminum Offline Posts: 998 Join Date: Oct 2007 Location: Colorado	01.12.2008, 02:55 AM Just resurected mustbnitro's dead MM Long story short, the solder from one of the caps was touching one of the buss leads. It actually had 12 burnt fet's and 2 that were cracked from taking the heat sink off. It has a few lifted traces and 3 of the copper sleeves that interconnect the pcb were pulled out so it took a little creative soldering. I didn't keep the mod though, didn't want to spend the time if it wasn't going to work and I'm not taking it apart again to try. So at this point it just has the better caps, diode, and deans wet noodle wire. Think I'll attach a fan and call it good. If I could only draw what I see in my head, then afford to build it, and finaly get to play with it...