RC-Monster Forums - View Single Post

GriffinRU · 05:36 PM

After successful install of CastleLink on Windows Vista, run some tests with all Mambamax ESC's.

It works fine with 3,4,5 and 6S LiPo with no problems (do not go over 25V, electronics inside will fail at 26V) when cutoff disabled.

It would arm properly with AutoLipo cutoff, but will not count more than 4 LiPo cell's, so testing in that mode is useless and can be unpredictable, think as if software would be sensing huge voltage drop due poor connections or whatever.

It won't arm with custom cutoff at all with 6S, two LED's would be half lid, I bet illegal state. I've tried 3 times and let it go, I was afraid of damaging ESC...

Bottom line, it works above 3S with any generation, but LiPo cutoff useless above 4S.

	(#14)
GriffinRU RC-Monster Aluminum Offline Posts: 748 Join Date: Oct 2005	01.12.2008, 05:35 PM After successful install of CastleLink on Windows Vista, run some tests with all Mambamax ESC's. It works fine with 3,4,5 and 6S LiPo with no problems (do not go over 25V, electronics inside will fail at 26V) when cutoff disabled. It would arm properly with AutoLipo cutoff, but will not count more than 4 LiPo cell's, so testing in that mode is useless and can be unpredictable, think as if software would be sensing huge voltage drop due poor connections or whatever. It won't arm with custom cutoff at all with 6S, two LED's would be half lid, I bet illegal state. I've tried 3 times and let it go, I was afraid of damaging ESC... Bottom line, it works above 3S with any generation, but LiPo cutoff useless above 4S. Last edited by GriffinRU; 01.12.2008 at 05:36 PM.