[Arct1k]

Trying to balance blowing up MM on 4s (I think due to cogging) and high motor temps.

I'm going to try direct soldering the motor leads but when I did my last test run motor was V hot to touch esc was cool...

This is for my MBX5 (MSR T) i.e. buggy diffs - 16/46 on 9XL 4S with MT Badlands.

Differential Ratio: 3.3333333333333335
Transmission Ratio: 1
Other Ratio: 1
Spur Tooth Count: 46
Pinion Tooth Count: 16
Total Voltage: 16
Motor KV: 1853
Tire Diameter (inches): 5.25
Tire Ballooning (inches): 0
Motor Current Draw: 0
Motor coil Ω: 0.0092
Spur/Pinion Ratio: 2.88 : 1
Total Ratio: 9.58333 : 1
Tire Circumference (inches): 16.49 inches (418.93mm)
Total Motor Speed: 29648 RPM
Vehicle Speed: 48.32 MPH (77.62km/h)
Effective Speed Rate: 3.02mph/V (4.85kmh/V)
Effective KV Value: 1853

I thought hot motor / cooler ESC was undergeared... It feels quick but not this quick...