RC-Monster Forums - View Single Post - E-Revo with Twin Force Tranny

Lonewolf039 · 01.15.2008, 09:33 PM

Tucks up real nice.

I had to space the motor plate up 3/8 inch to get the outputs in the right place. I used some delrin I had kicking around.

Motor plate and chain drive.

I am using Revo shafts on my Twin, so the outputs bolted right up.

I enlarged the front part of the frame 1/8 inch on each side to fit the tranny.

The tranny out of the truck. You can see the delrin blocks that everything bolts to.

Overall, I am quit happy with it. It is a little slower than a stock Revo, but a better motor will fix that in a hurry. With the two NiMH packs, all up weight is 10.5 pounds, so a good Lipo pack will also bring that down.

	(#2)
Lonewolf039 RC-Monster Carbon Fiber Offline Posts: 55 Join Date: Sep 2007	01.15.2008, 09:33 PM Tucks up real nice. I had to space the motor plate up 3/8 inch to get the outputs in the right place. I used some delrin I had kicking around. Motor plate and chain drive. I am using Revo shafts on my Twin, so the outputs bolted right up. I enlarged the front part of the frame 1/8 inch on each side to fit the tranny. The tranny out of the truck. You can see the delrin blocks that everything bolts to. Overall, I am quit happy with it. It is a little slower than a stock Revo, but a better motor will fix that in a hurry. With the two NiMH packs, all up weight is 10.5 pounds, so a good Lipo pack will also bring that down.